Home • All articles by author Routing enthusiast - Page 3
-
Skyworth SK-D849N will slow down after a period of time, solve the idea
Skyworth SK-D849N is an operator's customized optical cat, which is used as an AP after bridging, and the gigabit port rate will drop from 1000 Mb to about 180 Mb overnight, and it can be restored after rebooting or resetting the factory. For general AP speed drop troubleshooting experience, you can first put the particularity brought by the identity of "Lightcat-AP" in the first place, and then check according to the conventional wireless speed drop idea. You can find out what the problem is in the following order: First exclude the "optical cat + AP" firmware fix......
-
Teach you step by step to compile iStoreOS firmware and support all WXY products OEC, OES, JD Cloud, Netheart Cloud, Wanke Cloud and other PCDN cloud devices
recently looked at the iStoreOS firmware of OECT on the official account, and found that there are a bunch of people selling firmware on a certain fish, compiling the open source firmware, and starting to cut leeks, which is too black. Kwonelee's firmware iStoreOS supports almost all Wanke Cloud devices, from Wanke Cloud 3 and 3 PRO to OEC OECT, and then to OES OESP, which can support direct brushing. In order to prevent unscrupulous merchants from sending a cloud compilation method of GitHub Actions, compile the firmware in 2 minutes and give it to ......
-
TP-LINK MESH Networking Strange Problem: WAN port shows no network cable, but can I access the Internet normally?
tell you something, has anyone encountered a strange situation after using a TP-LINK router for MESH networking? Even though all devices can access the Internet normally, whether they log in to the APP or the web management background, it will display "No network cable connection at the WAN port". I encountered this problem before, and I was quite panicked at first, but later I found that I didn't have to worry about it at all, and it was useless to restart, probably a small bug in the router. ...
-
[Redmi AX3000/CR8809/CR8808/CR8806] Redmi AX5 and AX3000 brushed the inbound AP, and the 5G channel chose 36 but could only reach 40
question: Redmi AX5 and AX3000 brushed the inbound AP, 5G channel selected 36 but can only reach 40, using the latest official test firmware, I don't know if it is a display or firmware problem. Answer: The problem you encountered "5G channel selection 36 can actually only reach 40" is most likely due to a driver or UI display defect in the inbound AP firmware on the Redmi AX5 / AX3000, not hardware support it. The following are the reasons and tryable troubleshooting/solution ideas......

