How to close the mandatory registration interface after opening Telnet for mobile hx5-9halite

to the question "How to close the forced registration interface after mobile HX5-9halite turns on Telnet", the most effective way to do this is to manually mark the registration status as "registered" after logging in to Telnet to prevent the forced jump to port 8080. The steps are as follows (valid after 2025-12):

make sure you have Telnet turned on and can log in with your CMCCAdmin account.

log in and execute the following 3 commands (HX5-9halite uses sidbg, not sendcmd):

sidbg 1 DB set PDTCTUSERINFO 0 Status 0 sidbg 1 DB set PDTCTUSERINFO 0 Result 1 sidbg 1 DB save

restart Lightcat, and you will no longer be forced to jump to the registration page when you visit any webpage again.

If the registration page still pops up after execution, you can add another command to close ITMS (some firmware is valid):

sidbg 1 DB set MgtServer 0 Enable 0 sidbg 1 DB save

remember to restart reboot after the change. The whole process does not need to be disassembled, and it does not affect normal Internet access. I wish you all a success!

Under the moonlig...Reply

This method is effective and easy to operate, solves the problem of compulsory registration and saves a lot of trouble. It takes effect directly after restarting, and is recommended for users who have the same problem.

3 个月前

DawnReply

This method is quite practical, solves the problem of forced registration, the operation is simple and effective, it is recommended to try.

The ink turned whiteReply

This method is quite practical, it can solve the problem of compulsory registration in a few simple steps, saving a lot of trouble. As long as you remember to restart the light cat, it is quite safe to operate.

Son of the windReply

This method is quite practical, solves the problem of compulsory registration, is simple to operate, saves a lot of time, and is recommended to friends who have the same troubles.

4 个月前

The night is not ...Reply

This method is quite practical, it solves the problem of forced registration, and the operation is not complicated, the key is that the command must be accurate, don't make mistakes in the parameters, otherwise it may be counterproductive.

Dead leaf butterflyReply

This method is quite practical, solves the problem of forced registration, is simple to operate, takes effect after restarting, and is recommended for users who have the same problems.

The world is not ...Reply

This method is very practical, solves the problem of forced registration, and the operation is not complicated, suitable for users who do not want to disassemble the phone.

Walking fishReply

This method is quite practical, solves the problem of compulsory registration, simple operation, does not need to disassemble, the effect is obvious, recommended for users with the same troubles.

This method is very practical, solves the problem of forced registration, simple operation, no need to disassemble the phone, and you can access the web page normally after restarting, which improves the user experience a lot.

How to close the mandatory registration interface after opening Telnet for mobile hx5-9halite

Comment List

Contact Us

How to close the mandatory registration interface after opening Telnet for mobile hx5-9halite

Related Recommendations

Comment List

Contact Us