How to close the mandatory registration interface after opening Telnet for mobile hx5-9halite
SHUNOT• Publish Time:2026-1-5 09:48• Category: Router light cat
•Views:79316• Comments: (
0 )
to the question "How to close the forced registration interface after mobile HX5-9halite turns on Telnet", the most effective way to do this is to manually mark the registration status as "registered" after logging in to Telnet to prevent the forced jump to port 8080. The steps are as follows (valid after 2025-12):
- make sure you have Telnet turned on and can log in with your
CMCCAdminaccount. - log in and execute the following 3 commands (HX5-9halite uses
sidbg, notsendcmd):
sidbg 1 DB set PDTCTUSERINFO 0 Status 0 sidbg 1 DB set PDTCTUSERINFO 0 Result 1 sidbg 1 DB save - restart Lightcat, and you will no longer be forced to jump to the registration page when you visit any webpage again.
If the registration page still pops up after execution, you can add another command to close ITMS (some firmware is valid):
sidbg 1 DB set MgtServer 0 Enable 0 sidbg 1 DB save remember to restart
reboot after the change. The whole process does not need to be disassembled, and it does not affect normal Internet access. I wish you all a success! Read More


Comment List