• The AC2100 brush machine is brushed into bricks, the light does not turn on, and the TTL flash machine does not respond

    AC2100 (Xiaomi/Redmi) flashes and becomes bricked, the light does not turn on, and the TTL does not respond belongs to the deep brick machine state, which usually means that the bootloader is damaged or hardware problems. Here is a detailed brick rescue solution: 🔴 Problem diagnosis Light not on + TTL unresponsive Description: Bootloader (U-Boot) corruption - the wrong breed file may be flashed in or the flashing process is interrupted NAND flash memory problem - AC2100 uses NAND flash memory (non-SPI), programmer saves bricks......

    2026-1-29
  • Xiaomi AX3000T MESH network sometimes does not have Internet access

    Problem description: I use 2 Xiaomi AX3000T at home and set up 1 mesh, but sometimes I find that the mobile phone will be disconnected from the network when I swipe the video. Moreover, the mesh function of the sub-route can only be set to automatic, and if it is set to wired, it cannot be networked. The problem may occur: 1. The firmware has a timed disconnection bug; 2. Wired Mesh pair connection order, network cable, switch, main route, optical cat; 3. The wireless backhaul is easy to interrupt when the channel is crowded. Follow these 5 steps in order,......

    2025-12-2
  • After unlocking ssh on Xiaomi AX3000T, an error occurs when scp upload exceeds 20k.

    Xiaomi AX3000T official firmware write limit of 20 KB", the symptom is that as long as the file is transferred with scp as long as it exceeds 20 KB, an error will be reported, and it is basically certain that /usr/sbin/dropbear or /usr/bin/dbclient in the official firmware has been added by Xiaomi with a hard-coded restriction to prevent everyone from dragging large third-party packages (such as ShellClash, OpenClash, etc.) into the router at one time. Simple......

    2025-11-29
  • When using Redmi AX3000/CR880x with Jike AP, the 5G channel selected from 36 can only reach 40.

    question: Redmi AX5 and AX3000 brushed the inbound AP, 5G channel selected 36 but can only reach 40, using the latest official test firmware, I don't know if it is a display or firmware problem. Answer: The problem you encountered "5G channel selection 36 can actually only reach 40" is most likely due to a driver or UI display defect in the inbound AP firmware on the Redmi AX5 / AX3000, not hardware support it. The following are the reasons and tryable troubleshooting/solution ideas......

    2025-11-20

Contact Us

Online Consultation: Click here to send me a message

WeChat ID: master_135

Scan to follow