What to do if N1 turns into bricks, don't panic N1 The ultimate way to save bricks is here

first buy accessories online (see the picture below), and at the same time 6 yuan two eMMC masters for USB flash drive transformation.

to get to the point:

1. Remove the 8G eMMC on the motherboard, solder it to the eMMC master, insert it into the computer, and use Winhex to back up the original system into a bin file for later use.

2. Weld the eMMC 64G (by the way) on the C and D sides of the eMMC live base, and the A and B sides of the live seat on the EMMC position of the motherboard

3. Connect the 64G eMMC soldered in the live seat to the adapter board and USB card reader, and write the bin file of the first backup on the computer

4. Insert the eMMC live holder with the bin file on the motherboard, and pay attention to the correct pin position, otherwise the hardware will be damaged

5. Plug in and turn on, this is the original system, all settings are OK. After
, the eMMC live seat is unplugged, plugged into the adapter board and USB card reader, and the computer rewrites the backed up firmware (or official or other firmware) to successfully save the brick, the whole process takes a few minutes, and there is basically no uncertainty.