-
Download speeds are mostly cut in half because TCP re-uploads are being made up for patches; I counted the packets once more
The download speed suddenly dropped from 28MB/s to 3MB/s, and the web page is still spinning? Don't rush to scold the operator, 80% of the time it's TCP that is frantically retransmitting the patch behind the scenes. I used F12 and three pings to measure the packet loss rate and the number of retransmissions one by one, and then talked about which packet losses can be repaired by myself and which ones need to be reported for repair. ...
-
NAS reports hard drive failure, drive position lights, serial numbers, and indicator signals—three tricks to locate a bad drive
When a warning about NAS hard drive failure pops up on your phone, the first reaction is to panic, but the second reaction is the key: There are four plates inserted in four positions. Which one is broken? This article clearly explains the three-step method of checking the disk number - look at the disk indicator light, check the disk number according to the serial number in the background, and use the command to identify the disk in SSH. It will also talk about what will happen if the wrong disk is pulled out, and why it is necessary to copy the serial number first before replacing the disk. ...
-
Two phones test a 100Mbps speed difference with WiFi, five different places
For the same WiFi, my mobile phone measured 620 MB, but my wife’s phone only measured 480 MB. No one would accept the difference of 140 MB. After checking it all night, I realized that the two phones are different in terms of the number of antennas, supported WiFi levels, phone cases, and holding posture. This article breaks down the five sources of the speed difference between two mobile phones one by one and teaches you how to determine which phone is really slow. ...
-
Perform a health check on the router's management password; out of five checkpoints, two got infected
How long has it been since you changed the management password of your router? The default password left by the installation master, the same as the WiFi password, and the birthday mobile phone number are used as passwords. These are all vulnerable to dictionary attacks. I did a cryptographic physical examination on my backend. I passed five checkpoints one by one, and two of them were caught. This article explains clearly how to self-check, how to change a password that works well, and what three things need to be done after changing it. ...
-
Five situations where the password error for Xiaomi router 192.168.31.1 is reported
I entered the correct password for my Xiaomi router but it keeps getting errors and cannot log in. 192.168.31.1 ? I have helped my family members deal with this problem several times, and 90% of the time it is not that the password is wrong, but that the management password and WiFi password are mixed up, the browser fills in an old password, or the wrong password is entered continuously and the problem is temporarily locked. This article explains one by one the five situations in which "the password is correct but an error is reported", and each has a verification method that can be done on the spot. ...
-
The signal upstairs was poor, and the router antenna was broken all night. The slanted rod was a big contribution
How to place the router antenna correctly? The WiFi signal in the bedroom upstairs was poor. I unplugged the four antennas all night before trying to figure out the pattern.: Putting them all vertically is a two-dimensional thinking, and placing one diagonally is for feeding upstairs. This article explains the principles of antenna angles, the importance of placing 2.4G and 5G antennas separately, and things to think clearly before replacing high-gain antennas. ...
-
The optical modem accidentally pressed reset to clear registration data, and the three-step approach saved broadband back
What will happen if the reset button is pressed on the optical modem? Restore the factory to clear all registration data such as LOID and VLAN, and the optical modem becomes a machine that does not recognize your home broadband. This article is about my complete self-rescue the night I pressed reset by mistake.: First confirm that the cat is still alive, then call the operator to get the registration code back, and finally fill in the code on the registration page. The whole process did not cost a penny and did not go to the business office. ...
-
Mercury Tengda router channel has been switched from automatic manual selection, so WiFi at night is no longer laggy
Where to change the channel of Mercury Tenda router? The channels of both companies are hidden in the wireless settings, and the default is "automatic". The automatic channel is only selected once when restarting, and it will not change when neighbors gather to surf the Internet at night. This article is about the whole process of helping two machines upstairs and downstairs change from automatic to manual selection.: The two locations of Mercury's old and new interfaces, the two generations of Tenda's firmware entrances are different, and there is also a formula that only recognizes 1, 6, and 11 for 2.4G. ...
-
After switching to a telecom optical modem bridge, the landline has no sound, so first check the voice WAN
After the optical modem was changed to a bridge, the broadband was smooth, but the landline phone had no dial tone. This happened to me once when I failed to copy the voice WAN parameters. This article explains why bridging interrupts calls by the way, which sets of parameters should be copied down in advance, and how to arrange the recovery order. If you follow it, you won’t have to wait for the master to come to your door. ...
-
Turn off the router once a day, check the meter, and after calculating the electricity bill, you won't have to worry about it
Should the router be turned off once a day? I used the metering socket to calculate the electricity bill. It cost 24 yuan a year, which could not save me a breakfast. After a power outage, the system time resets to zero, scheduled tasks follow, and more than 40 smart devices collectively reconnect. Turning it off once a day is even more troublesome. This article explains once and for all whether it should be turned off and under what circumstances it should be unplugged. ...

